languid birch
Hey guys, I have been working on getting my E5+ with a Skr 2 board calibrated. But I am having an issue with the z-offset. I homed the printer, leveled the bed manually. I then ran the probe calibrate to set z-offset. However, it wanted to go past the -5 setting. So I bumped it up to -10 still needed more. Long story short, I have to set it to -25 just to get my z-offset low enough to print.
So my z-offset in the printer is like 20.05. I know this is no where near normal. Printer is still using the stock HE assembly with BLTouch (for now). Is there something mecahnical I need to check/change to get the z-offset number closer to -2.???.
[stepper_z]
step_pin: PA15
dir_pin: !PA8
enable_pin: !PD1
microsteps: 16
rotation_distance: 40
endstop_pin: probe:z_virtual_endstop
position_min: -25
position_max: 400
I've had enough today, will pick this back up tomorrow 😦
late ledge