velvet thorn
Im doing some speed testing right now, not printing, just moving X &Y.
Im good up to 200mm/s. At 250 I start to hear a moaning sound and also skipped steps.
Is this the max speed I can expect?
Belts were tensioned to 110hz, I will recheck now that its been run a bit.
Also what acceleration & jerk settings are recommended? Im looking to maximize speed but still produce quality prints.
velvet thorn
update: I realized my config file still had the motor run current settings from my stock E5 motors. I bumped it up to 1.5 amps and the noise is quieter and doesnt start until 300mm/s and no more skipped steps
next holly
should be able to get in the 400 range, at least for travels. Im currently printing at 100mm/s first layer, 120 perimeters, 175 infill. 5 pro