I was flying on vatsim from JFK to MEM about half way through I notice my place on about a constant 2 degree bank I then disconnect the autopilot to fix it then noon of the control surfaces are responding and the pfd’s and nav display and both sides freeze on a set image I unplugged my control stick ti no avail and reconnected auto pilot multiple times the trim wheel didn’t move when I tried to spin it while my fly pad was and is up to date with stable v10 eventually I ended up leaving that flight with the problem not solved
#all place control surfaces not responding
rugged tendon
marsh emberBOT
strong hawk
I was flying on vatsim from JFK to MEM about half way through I notice my place ...
You sure you weren't on active pause in the sim?
rugged tendon
You sure you weren't on active pause in the sim?
no the sim was still moving the plane dropped about 10000 feet because the backup display was working but no control surfaces "other then flaps and spoilers" were working and non of the 2 primary displays
also tried reseting all the different systems to no avail
eternal acorn
No flight controls would tell me systems wasm crash but if spoilers were moving that cannot be this
rugged tendon
No flight controls would tell me systems wasm crash but if spoilers were moving ...
Sorry I meant that rudder elevator and ailerons were not responding and most important displays were frozen
The master warning alarm did go off but no new messages on the e cam and the light wasn’t illuminated
eternal acorn
If it’s a wasm crash, even rudder pedals wouldn’t respond. You think it was the case?