when I set the initial glow settings, and install the firmware, it doesn't seem to change, I think it has something to do with flash memory, I don't know
#I do not know how to explain this, but it's about updating rgb
buoyant pewter
the color of the old firmware remained on one half, and the new one on the other
and when both are connected, the new one does not work at all
buoyant pewter
and I understand that the configuration is not updated only from the rgb
buoyant pewter
There is some crap going on, the rgb backlight after connecting the usb on the left side does not work immediately, unlike on the right, only after the right part goes into sleep mode, when interacting with the left part it starts working, right now at the time of writing, the left one glows and the right one does not, there are no problems in soldering here, tk everything was fine until I started experimenting with CONFIG_ZMK_RGB_UNDERGLOW_BRT_START. right now I have flashed them back to a more or less initial position, but the rgb behaves extremely unstable, the left part is lit right now and the display is not. I don't know what's going on
