Ender 3V2 Starting Print at Max Z

[rotund tundra]

Hey all! I just installed a Micro Swiss extruder head to help my Ender 3V2 produce more efficient and quality prints for my scout trooper helmet project. Unfortunately, I was running tests to make sure everything was up to par and my extruder will begin printing at the max z after auto homing during print start up.

I've looked into the .gcode settings in Prusa Slicer since I just set up my printer in there and got no results from research and my own tinkering. If anyone has run into this problem before, please reach out!

Thanks!

[stoic grotto]

Hey @rotund tundra, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

[tranquil marsh]

Vid?
Does it do that on every print? Or just the one model?
When you installed the new head system, did you also then install a bltouch? Or still using the z homing switch?
Did you make any settings changes to accommodate the new head? (like did you accidently set z offset to a ridiculous value?)