quiet ember
hey all.
long story short up until recently I've been using pla then took a chance at silk and it worked great.
but trying to switch back to pla has been some trouble.
at first I thought it was a clog so checked out the hot end that was fine cleaned off the side of that and the yellow disc thing. put it back together and I'm still getting blobs any ideas whats up?
(Bambulab p1p)
fringe forgeBOT
Hey @quiet ember, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.
quiet ember
adding some of the settings here in case it helps
karmic pelican
After removing the hotend and replacing it and opening up the extruder (that"s the yellow cogwheel), the balance of your toolhead and z-offset are changed.
So you have to do all calibration from the start, input shaping, dynamic flow etc. Basically a factory reset.
Did you do that?
quiet ember
if you're talking about this one yeah. done it a few times
