✅ - I've never done any post processing, how should i fix this?

[lavish bramble]

I recently printed this wolverine mask and i have some layer shifting in the front but none in the back. I was wondering how I should finish this. I have some bondo body filler if i need to use it.

[novel oasis]

Hey @lavish bramble, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

[stoic night]

It looks like there could be a partial clog that happened there

How is the strength

[lavish bramble]

It's strong. No bending or separating

[stoic night]

Alright so what I would do is sand these area with 80 grit, then use a soldering iron or a wood burner to melt it shut, I would then sand it again with 80 and fill that with bondo, then refine the grits from 80 - 180 - 220 then primer - 600 grit - paint - clear

[lavish bramble]

Ok. I'll try that out thanks!

[stoic night]

No problem

[lavish bramble]

Do you know what I can do mechanically so that it wont happen again?

[stoic night]

Make sure your belts are properly tensioned

[lavish bramble]

I probably need to do some calibration anyway. Change the tip too

[novel oasis]

This thread is closed now :white_check_mark: