✅ - Filament won’t stick to build plate

[sour bobcat]

Whenever I try to print something the filament won’t stick to the plate. I’m using an Ender 3 Max with Hatch Box 1.75 mm PLA filament. I extrude at 220°C and have the build plate at 70°C. I always make sure to level the plate before printing and I know for a fact that all of my screws and wires are connected in the right place. I have the print speed set to 100 mm/s if that helps.

[tired jay]

Hey @sour bobcat, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

[obsidian fulcrum]

Dude...

Why so hot on bed and filament? O.o

Also did you clean your bed? if so with what? Ender 3 max has the creality glass bed. Still have that? @sour bobcat

[sour bobcat]

I cleaned it yesterday with 70% isopropyl alcohol

[obsidian fulcrum]

bad.

Creality beds dont like IPA

use window cleaner with a mircro fiber cloth... and lower your damn temps.... too high for pla... 200/60 are a nice safe zone until you need to temp towers.

and make sure to level the bed and print a bed level test to see if you need to tram the bed some. (adjust the knobs as it prints.)

[sour bobcat]

Thank you

[sour bobcat]

Will this work or is there a different type you recommend?

[obsidian fulcrum]

should be ok

[sour bobcat]

Coolios

[tired jay]

This thread is closed now :white_check_mark: