Question about co2 use and pressure rating of items | Frankly Built's 3D Printing & Cosplay Community | Page 1

I Am looking at this setup:
You familiar with small scale pneumatics able to tell me if the setup I mentioned above will work? 😄
12g CO2 adapterhttps://www.amazon.com/dp/B00GW9KFP8/
connected to on/off ASA regulator https://www.amazon.com/dp/B07BD3R2XT/
connected to adapter https://www.amazon.com/dp/B084ZDT4VY/
connected to solenoid https://www.amazon.com/dp/B09H42GCHG/
Ive been told the setup would work theoretically, but I have concerns given the pressure differences.
From what I've read, the co2 canisters have around 800psi
The solenoid and adapters I see say pressure ranges up to like 145. So how does that work? O.o

Paintball Quick Change 12 Gram 12g Co2 Adapter Black

This Up for sale is a device that allows the use of 12 gram CO2 cartridges in any marker with a standard ASA tank thread. Nothing elaborate about using it. You just attach the front piece to the standard ASA, slip a 12 gram CO2 cartridge in the rear tube, and tighten. The cartridge is pierced and...

Sconi ON Off 2 Port + Gauge for Paintball - CO2 Fill Adapter - Remo...

This is a universal air adapter for CO2 fill stations and remotes. This adapter includes 2 output ports, 1/8 NPT, and a 1500 PSI gauge installed in one of the ports (with thread locker). Material: Aluminum Alloy 6061-T6

Joywayus 1/2" G Thread Female × 1/4" NPT Thread Male Brass Pipe Fit...

Joywayus 1/2" G Thread Female × 1/4" NPT Thread Male Brass Pipe Fitting Adapter (Pack of 2)

TAILONZ PNEUMATIC 1/4 Inch NPT 12V 2 Way Normally Closed Electric S...

TAILONZ PNEUMATIC 1/4 Inch NPT 12V 2 Way Normally Closed Electric Solenoid Air Valve 2v025-08 Outlet Wire

#Question about co2 use and pressure rating of items