fringe patio
These are the temp tower pics. I would have expected more of a difference between each. On the front, a difference I see is underneath the bridge.
I have calibrated esteps and flow. I'm using eSun PLA+
It's hard to get a retraction test picture but each (I did starting at .5mm and incrementing by .5mm) are all consistently bad.
pulsar matrixBOT
Hey @fringe patio, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.
fringe patio
I noticed I had some Travel settings set, and the retraction test looks a lot better with those to the default (may need help with those settings after)
fringe patio
Any thoughts?
haughty talon
did you watch the printer change temps? I had a hell of a time getting a temp tower to work correctly even after doing what I thought was exactly the right thing. I had to change manually as it went
fringe patio
I didnt watch it but I see M104 commands in the gcode
haughty talon
I'm pretty sure my gcode looked correct as well, but still didn't change. It was a while back I created the file and the last time I used it the mofo didn't change temps
fringe patio
@haughty talon any idea what it could be?