Been much more difficult to remove (even went back to the alpha+christmas Cura I was using thinking maybe it was Cura 5.4. Same issue. If I can get something wedged in there they usually come off clean, but they used to just pull right off.
Did I mess up a setting? These are my support settings (0.2mm layer height)
#issues with rafts and supports lately
vernal niche
native oxideBOT
Hey @vernal niche, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.
vernal niche
fair ridge
What are the setting on your support top and bottom distance ?
vernal niche
What are the setting on your support top and bottom distance ?
should all b in the screenshots
vernal niche
id recommend to go back to standard settings
For everything? Or just rafts and supports?
brave birch
for me, i just reset everything to standard because my printer had several issues and it was apparently all just software issues
you decide what to do for you
errant cairn
Might be that branch density at 30%. Mine pop right off. I’ll check my settings in a bit but I believe I lowered mine down to 5%
Also your support density is at 0%. Not sure if trees over rides that but put it back to 4-5%
errant cairn
trees do 0% usually
Gotch. Well either way my branch density is set to 5%