pine jewel
Hello!
I got some issues while printing something to hang on my wall. I don’t know why, but in a specific area of the print surface it gets these „scratches“/„blobs“. But it only appears after several layers. Also on the other side this doesn’t happen:
sonic canopyBOT
Hey @pine jewel, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.
cinder wadi
that usually means you are too close to the bed (for the first few layer), or overextruding a lil bit
you can solve it by leveling the bed and calibrating e-steps and flow rate %
pine jewel
Well i already reduced flow rate and have a auto leveling sensor. Its super weird, that "every second layer" seems to have these issues
pine jewel
It’s always the same edge
