native egret
After removing the supports on my print i noticed these weird lines on my print. they are only present on a small part of the front of the print and weak. is there anyway i could strenghten it? i really dont wanna print it again since it only shows up there.
wanton stratusBOT
Hey @native egret, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.
real hill
You could try superglue and baking soda then sand it down but it’ll take a while
tardy current
I was about to recommend the same thing. I suggest trying to get the baking soda in first then drip some thin superglue. It will be better with thin superglue because it can seep in and saturate all the baking soda
native egret
thanks for the tip. i will try it tomorrow when i get home from school