✅ - x gantry wheel frame

[forest yoke]

So I had ordered a cr-10s pro v2 sometime back. And after unboxing the first thing I noticed wrong was that the gantry wobbled. So I knew to tighten the nut to fix this issue but it seemed no matter how tight I made the nut it would not fix, then I had to take apart the hot end the other day and noticed this bend in the frame. Could this be the reason for the never ending sable and if so where could I buy a replacement frame?

[lofty seal]

Hey @forest yoke, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

[forest yoke]

Dang thanks 🥲

[maiden bronze]

I have a cr10s pro v2 and just checked it. That does look bent the wheels should be in line with each other. looking down the from the direction you have it now.

You can see if Creality has the part to replace it. Or you could try to fix it yourself by benting it back straight. By taking off the guide wheel stud there and BL touch bracket and BL touch itself. Putting the bent part in a vice with two pieces of scrap wood to keep from marring the bracket where the bend is and slowly close the vice till it flattens the bend out.

You could do the same thing if you don't have a vice, lay it on something flat then get a scrap piece of wood to lay over the bent area and Tap it down with a hammer to take the bend out.

It is aluminum so it won't take much to bend it

[forest yoke]

Thank you brother!

[lofty seal]

This thread is closed now :white_check_mark: