I recently starting 3d printing again, and have been having adhesion probs w/ my Anycubic Kobra MAX | Frankly Built's 3D Printing & Cosplay Community | Page 1

brave trellis Apr 13, 2023, 6:58 PM

#

I never had any issue before using the bed that came with it and same settings I use now. Now It seems ANYTHING I print that I dont use a brim or raft on will come off and spaghetti, even small objects. Even had a rafted one come off
Tried cleaning it with the isopropyl alcohol to no avail.

fair inletBOT Apr 13, 2023, 6:58 PM

#

Hey @brave trellis, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

brave trellis Apr 13, 2023, 9:42 PM

#

I printed a bed leveling test, which turned out fine, except this one corner. Im not sure whats happening here.
After that I went for a temp tower (did one of these originally for this filament before and it printed fine). I quickly noticed one end had peeled up.
I never had these issues with this printer/filament last time I printed (month or 2 ago). I dont get it.
It's PETG

tardy ferry Apr 13, 2023, 10:20 PM

#

Someone will probably have a better solution than what I'm about to say but I think this might be a temp solution for you.

Try using PritStick or GlueStick on the print bed.

Yes yes, I know it sounds odd, bizzare, silly etc etc and I said a whole lot of things to my wife when she suggested it. But we did it, and I've had no issues with adhesion to the buildplate and surprisingly it doesn't gum up our build plate either

#

So yeah, just spread some around on the surface and try printing again. We didn't need to use too much either

brave trellis Apr 13, 2023, 10:46 PM

#

Tried that after previous spaghettis. The ones pictured are with glue stick applied. Still happened

brave trellis Apr 15, 2023, 5:00 PM

#

I guess at this point I just need to hope its the filament and PLA will be fine

tardy ferry Apr 15, 2023, 6:29 PM

#

have you made sure that one particular corner is level?

brave trellis Apr 17, 2023, 12:30 AM

#

It's full auto bed leveling, but I tested again anyway, manually. It seemed one side was higher. But after running ABL again now its the opposite? I dunno. I think there may b an issue with the ABL

#I recently starting 3d printing again, and have been having adhesion probs w/ my Anycubic Kobra MAX