supports hard to remove

[civic narwhal]

So the supports are super hard they are 15 density infill and still super hard to remove it's like it's merged with the print itself. Any tips on how to make the supports easy to peel off or not be fused with my print

[lilac aspen]

Hey @civic narwhal, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

[woven snow]

Increase your z height in cura.

Are you using 15 for support density?

[civic narwhal]

Yea

Do I increase my x height for the distance of my supports?

[woven snow]

Support z distance is what it’s called in cura

Also lower your support density. That’s too high

And try using tree supports for that

[civic narwhal]

Ohh 15 is high I was thinking was starting to be low you thinking 5% would be better?

[woven snow]

If you’re taking about support density, I use 1-2% when I use trees. If you’re taking about infill density, I use between around 7% for most props

[civic narwhal]

What’s the difference sorry I’m still a bit new to this 😣

[woven snow]

Support density is the density of the supports, infill is the inside of your prop

[civic narwhal]

Theirs no stock option for the Libra Mac on cura had to make custom profile

Ohh gotchu I read super density my bad