help plz

[hearty cairn]

Any idea why this is happening? I just cleaned out the nozzle and tested it after this and it’s not clogged

[fickle kelp]

Hey @hearty cairn, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

[noble birch]

looks like a clog

howd you clear the clog?

[hearty cairn]

I took off the nozzle and the top piece (forget what it’s called, the part the tube goes into) I cranked it up to 230 and pushed the petg tube thru until I cleared out the gunk and then put it all back together

[noble birch]

thats right... i would try again make sure you put the bowden through all the way when the nozzle is back on.. and the filament is coming out straight after

[hearty cairn]

It comes out straight when I push it through

No curling or anything

But I’ll try again

[noble birch]

is that using the etruder?

extruder

or by hand

[hearty cairn]

By hand

[noble birch]

try the extruder

[hearty cairn]

Sorry I’m not following

[noble birch]

you can use the controls to run the extruder

[hearty cairn]

Oh

I didn’t know that

[noble birch]

your hands have more power than the stepper

should be under prepare-move axis... extruder

[hearty cairn]

Ok thanks I’ll try that

[noble birch]

np

[hearty cairn]

It looks fine with extruder

@noble birch

[noble birch]

Perfect. Print?

[noble birch]

If it persists calibrate your esteps