✅ - Poor support contact

[ornate ermine]

I've been having issues with my support settings when the supports need to actually touch the model but I can't seem to get the supports close to the model and don't know what settings to use. I've started using tree supports for the first time and as you can see on this bulbasaur print, the supports weren't even touching the print. I've also attached my cura settings. I'm getting droopy loops of filament at the start of steep overhangs. Any help would be appreciated thanks.

[somber tree]

Hey @ornate ermine, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

[ornate ermine]

The bottom of the bulb where some parts of the print were printed only on the supports until they met with the main print

[ornate ermine]

Nothing?

[ancient cove]

you can try to turn temp down or suport density up a little it wastes a lot of fillament though and would just sand it if possible

[somber tree]

This thread is closed now :white_check_mark: