So my latest print has these things, im not sure what to call them but I was wondering if the cause was because I need to readjust the belt tension or if it’s caused by something else
#belt tensioning?
rose spruce
lusty shoalBOT
Hey @rose spruce, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.
timber arrow
Its related to stringing, some filament ooze from the nozzle during travel
Its easy to clean up, the print itself looks fine
rose spruce
Nice, I just wasn’t sure if I needed to fix something
timber arrow
The "whiskers" seem to start at the top half of the print. Most likely due to imyour printrr doing a lot of retaction at that part
I have not found the best solution for it though
rose spruce
Ah okay, so there isn’t really a fix to it? Just happens sometimes?
timber arrow
Thing is there is a lot of things that can cause that.
Temp too high
Retraction speed too slow
Part cooling fan not enough cooling
Minimum retract distance
Etc...