✅ - In Fusion 360 how do I edit a part?

[sharp dune]

I designed a hook that we are using in Ninja Warrior training, I put a loop on the top and one on the side. Now I want to remove the side loop. I can't figure out how to change the design.

I'm pretty new at this, I tried going into sketches but can't seem to find a way to erase it. Is there some other way to adjust it?

[royal belfry]

Hey @sharp dune, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

[lone vortex]

You need to have “Capture Design History” enabled (you should see a timeline of actions at the bottom)

[sharp dune]

that worked. I didn't realize I wasn't in full screen, it looked like it was. Once I did that I found the history at the bottom.

[royal belfry]

This thread is closed now :white_check_mark: