So I’ve leveled my printer a few times and everything’s level. Then when I go to run the print and the bl touch does it’s thing automatically before a print, the nozzle ends up like 10mm above the bed Avenue though it’s perfectly level. I keep having to turn the adjustment knobs so it can meet the height of the nozzle but at some point the wheels are just gonna fall off. You think it could be an issue with the bl touch?
#CR 10 s pro v2 leveling and BL Touch
humble totem
analog nacelleBOT
Hey @humble totem, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.
remote atlas
When you're at the leveling screen and you press z home,is it just above the bed or floating?
Cause if it's too high when you press the home button it means you need to adjust your z offset (the up and down arrows) until it's close to the bed.
dawn lotus
I got my cr10s pro v2 used. When I hit “home” it always sits 12.4 above the bed. But when I hit the “levelling” button the nozzle sits where it will print from. I’ve had good prints come off it so I don’t worry about where the nozzle sits at the “home” state. But I’m also new to this game..
unreal abyss
Had this issue for weeks and im going insane... on the off chance a print starts off looking like it will go smoothly. An hour later I look and it's floating...my brain says z steps... like every layer gets slightly further away from the last until the gap is noticable