#✅ - magnets for an ant man helmet

8 messages · Page 1 of 1 (latest)

unkempt tapir
#

So I’m printing the ant man helmet from Walsh 3d and there’s holes for magnets in it but I don’t know what to look for when shopping for magnets and I’m wondering if these will be strong enough to hold the magnet together https://a.co/d/hnczjQv
Also here’s a picture is where the magnets would go

IMG_4985.jpg
100Pcs 12x2 MM Rare Earth Magnets Magnets Multi-Use Tiny Sliver Mag...

100Pcs 12x2 MM Rare Earth Magnets Magnets Multi-Use Tiny Sliver Magnets for Fridge Whiteboard Dry Erase Board in Home Kitchen Office and School

cinder tigerBOT
#

Hey @unkempt tapir, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

severe hazel
#

They look good to me, just make sure they are the right size for the holes. I usually ask the model maker if unsure on the size.

unkempt tapir
#

Well this ant man helmet it really small at 100% so I scaled it up and measured the hole with calipers

#

I also printed 12mm x 2mm cylinders and measured them and they fit pretty good in the hole

severe hazel
#

Good planning.
You should be fine with those magnets then, you won’t get much stronger at that size.

unkempt tapir
#

Alr I’ll make sure to post updates as I get more of it done

cinder tigerBOT