✅ - stringing

[wary loom]

#help-printing
I have tried so much, coasting, zhop, temp, retraction distance, retraction speed, wall optimisation and movement speed. If anyone can help with the stringing I’d be so thankful.

[eager timber]

Hey @wary loom, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

[vocal tangle]

Have you checked for a clog?

[wary loom]

Yeah, took it apart and cleared it

[vocal tangle]

This looks like a clog or very bad underextrusion. How did you clear the clog!

[wary loom]

I followed these steps

[vocal tangle]

@olive jolt think this looks like a clog or something else?

[olive jolt]

Looks like partial clog

could also be the bowden tube is not sitting flush against the nozzle

[olive jolt]

did you use a new nozzle?
how did you cut the bowden tube? make sure it is sitting flush against the nozzle

[wary loom]

@olive jolt @vocal tangle no I didn’t change the nozzle, I’ll give the printer another clean and change the nozzle, I appreciate the help!

[olive jolt]

let us know how it goes

[wary loom]

@olive jolt @vocal tangle hi guys, sorry that it’s taken a while, I’ve cleared a clog and replaced the nozzle, this is the result

[wary loom]

It’s a lot better on an actual print

[wary loom]

Would just like to say thankyou for your help and patience guys!

[eager timber]

This thread is closed now :white_check_mark: