y axis belt problem | Frankly Built's 3D Printing & Cosplay Community | Page 1

coral ravine Nov 8, 2022, 5:39 PM

#

I just went to go and print an iron man glove and noticed that my y-axis belts had something wrong with it on both sides in the exact same place. Do I need to replace them? And if so where can I get some? my printer is a kobra Max.

signal perchBOT Nov 8, 2022, 5:39 PM

#

Hey @coral ravine, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

hasty sun Nov 8, 2022, 5:41 PM

#

I just had my y belt snap.

#

3D Printer Belt 5M GT2 2mm Pitch... https://www.amazon.com/dp/B07BBK1L15?ref=ppx_pop_mob_ap_share

3D Printer Belt 5M GT2 2mm Pitch 6mm Wide CNC for Prusa i3 Anet A8 ...

3D Printer Belt 5M GT2 2mm Pitch 6mm Wide CNC For Prusa i3 Anet A8 Accessories Eewolf Belt Material: Neoprene (Synthetic Rubber) Belt Type : GT2 / P2M Pitch (mm) : 2 Belt Width (mm) : 6 Core Wire Material : Glass Fiber Circumference Length (mm) : Open Loop Belt Shape : Open End Belt Tooth Surface...

#

I have a cr10 v3. I got this and it looks like i can replace 2-3 belts with what I got. Just got it last night and have not had a chance to run a print yet. I haven’t had a chance to level and tighten everything back up.

coral ravine Nov 8, 2022, 6:48 PM

#

Do I need the things that go to the end of them?

hasty sun Nov 8, 2022, 7:51 PM

#

Just folded the belt over on its self and used zip ties. I found a Reddit thread and someone suggested not needing the end clamp things.

#

I can’t find the thread. Here are the clips that were listed with that same belt I ordered above.

#y axis belt problem