terse jolt
Hello everyone I bought a file from do3d for a Deadpool mask and I keep getting this error message from cura. Anyone know what the issue could be? I have an ender 3 but I read online the error message was because the part was too big for my printer so I tried it again with a cr10s in cura and still got the error message.
Also it’s only with this part file not others. Thanks in advance.
Cura version: 5.1.1
Windows 10
pulsar panther
You might have some incompatible settings selected in Cura. I had this happen one time and I messed with the settings and was able to print. I don't remember the actual problem though.
terse jolt
I’ll try to continue messing with settings. Thanks 👌🏼. Do you have an idea of setting in particular? Like supports? Adhesion?
pulsar panther
I can't remember what it was, but more like selecting vase mode on that model. Or something else impossible so it tries to slice and it goes for much longer than normal then fails. Try loading a new instance of Cura with default settings, then tweak it back to the ones you normally adjust.
terse jolt
I can't remember what it was, but more like selecting vase mode on that model. O...
Good advice. Thanks again 🙌🏽