Cr-10 thermal runaway error | Frankly Built's 3D Printing & Cosplay Community | Page 1

vast hawk Oct 7, 2022, 2:49 AM

#

i've been getting a thermal runaway error on my cr-10 multiple times not quite sure how to fix this checked the hot end replaced nozzle replaced teflon tube changed filament nothing has worked yet any help would be greatly appreciated!

full haven Oct 7, 2022, 5:11 AM

#

Either your heating element or thermistor is damaged, check for those

vast hawk Oct 7, 2022, 5:11 AM

#

Ok i'll check is there somewhere specific on the printer i need to look?

full haven Oct 7, 2022, 5:14 AM

#

Either the hotend, or bed

vast hawk Oct 7, 2022, 5:14 AM

#

ah ok i'll check those i was planning on ordering a new hotend anyways so hopefully that will work

full haven Oct 7, 2022, 5:16 AM

#

you can narrow it down by heating either the bed or hotend separately

#

if the error happens when you heatup the hotend but not the bed, then the problem is in the hotend and vice versa

vast hawk Oct 7, 2022, 5:17 AM

#

I forgot to check those lol im hoping its my hotend that i at least know how to fix

full haven Oct 7, 2022, 5:18 AM

#

check for these wires in the hotend, usually its the wires

#

if you need to disassemble them be very careful as they are quite fragile

vast hawk Oct 7, 2022, 5:19 AM

#

ah ok i've seen those before is there a certain way they look if they are damaged?

full haven Oct 7, 2022, 5:19 AM

#

wire snapped

vast hawk Oct 7, 2022, 5:19 AM

#

ah ok yeah i'll for sure check those

#

thanks so much for the help i appreciate it

#Cr-10 thermal runaway error