I have had no problems in the past with filament breakage but in the last week I have had about 5 filament breaking mid print about 1-2 hours into the print. Anyone know a good fix?
#My Filament keeps breaking
novel mesa
wise hull
Mine too
devout coral
Same filament?
Is it pla? And is it dry?
wise hull
Pla + on mine and have not used it since I put it in few months ago sorry not my post hope I don’t get in trouble for following up just have same problem
devout coral
Pla + on mine and have not used it since I put it in few months ago sorry not my...
Filament may get brittle when it takes on a lot of moisture. Some filament can just be brittle though. I had two of the sample rolls that came with my cr10s and one of them was pretty brittle even after drying the other wasn’t as brittle
wise hull
I’ll change it and see how it goes was having problems with the extruder was chipping away the filament also so took a few months break lol