pseudo vector
Hey, so I bought and I assembled an Ender 3 recently and I tried to follow the tutorials on bed leveling. When I tried to do the paper thing, the space between the nozzle and bed is too big so no matter how much I turn the wheel under the bed, it’s not getting close enough! What do I do?
strange matrix
You have to loosen the bed screws for the bed to raise tight ingredients them will make it drop
astral night
Hey, so I bought and I assembled an Ender 3 recently and I tried to follow the t...
your bed spring seem to be fully compressed aka making the bed lower you have to turn the knobs to the left to raise the bed
pseudo vector
I raised but there’s still some space in the middle. I’ve noticed that the nozzle is more extended in some videos. Is that something?
astral night
if thats the highest your bed can go I suggest lowering your Z limit switch at that point
this is the video I used for mine
pseudo vector
I’ll try it and see tyty
astral night
side note in the event that you upgrade your springs (which I highly recommend you do) you will probably have to raise it back up
also I recommend you have your springs at a mid way point instead of fully lose or fully tight when moving the Z stop incase of an event where you need to adjust your bed