The first couple of layers looked great. I left my print and came back to this.
#what is happening?
drowsy delta
gleaming kite
Clog
Fire up the nozzle to 230. Take off the Bowden. Take off the nozzle. Take off the coupler. Take some Bowden tube then feed it through to scrape the inside of the hot end. Put the nozzle on. Then push filament through it and make sure it comes out straight. Then put it back together. Make sure the bowden is cut straight and clean too
raw ruin
i dont know if its just a bad angle, in the picture your nozzle looks bent?
drowsy delta
i dont know if its just a bad angle, in the picture your nozzle looks bent?
The housing was side ways because the nozzle was caught in the print
drowsy delta
Fire up the nozzle to 230. Take off the Bowden. Take off the nozzle. Take off th...
Just ran a filament change and filament came through perfect. It's all new I just replaced the entire hotend.
raw ruin
The housing was side ways because the nozzle was caught in the print
which housing?
is the hotend properly assembled after you replaced it?
because the nozzle seems to be lower than the print which shouldnt happen
drowsy delta
which housing?
is the hotend properly assembled after you replaced it?
because t...
Everything attached to the x axis. It looks like some layers printed higher than others but I did not see that on the first few layers. I replaced the entire hotend after trying to fix the same issues with the one that came with the printer.
I just did a raft and there's this one section on the left side of the picture that isn't level but it's only one section. Both sides of it look fine.
