Endstops not working regardless of settings | Reprapfirmware, DSF and DWC | Page 1

noble raptor Sep 28, 2024, 10:38 AM

#

on the second picture two of them look like the crimps are touching

#

did your board come with crimps? you might wanna take your time and recrimp your wires so they can use the housings that likely came with your board

#

I went through that process myself, try having some youtube or something to make things less monotonous while you crimp your wires

hidden cloak Sep 28, 2024, 4:54 PM

#

Would be a lot easier to debug if you'd use the correct connectors. If you're having issues with just the 2 wires adding the voltage wire which i not needed for end-stops, is a recipe for disaster.

lime surge Sep 28, 2024, 6:58 PM

#

I was just checking for proof of concept. I literally have done this method on four other rebuilds I'm in the middle of and knock on wood not had issues. I was crimping the correct ends when I made the new three prong cables

#Endstops not working regardless of settings