Hello all. Bit of a panic as I was planning on using this for Halloween tomorrow night. I have a Korbanth Starkiller v2 with a proffie board. Everything has been working fine. Today after charging the battery, the blade suddenly doesn’t ignite. Tried 3 different batteries. Switched to a different blade. Both blades work in a different saber. The hilt itself lights up, plays sounds, etc but the blade doesn’t light up. Any suggestions?
#Hilt lights up but saber doesn’t
bold geyser
remote grail
measure DC voltage at the hilt-side pogo pins, should be battery voltage.
Measure AC between the center data pin and negative. There should be fluctuating small pulses when the blade should be on and running.
If either of these fail, your blade won't light up.