untold fern
Hi, I'm trying to figure out how exactly to setup a mesh with the BLTouch, I tried googling it and searching on YouTube, but not seeing a lot of options for me. Would someone be able to help me out?
I've just flashed the new firmware from https://github.com/CopterTec/Marlin-Sovol_SV01/releases
It flashed properly and changed on my actual printer, but I have no idea how to setup the Unified Bed Leveling.
mental heath
You want Unified and not Bilinear?
untold fern
I would be happy with either, but the firmware I installed has Unified. and I downloaded the above firmware, I don't see any options besides unified and level corners.
I can send some screenshots.
I just want to be able to use my bltouch properly with my printer 
These are the commands under bltouch on configuration
tardy birch
You change that before compiling
subtle pivot
These are the commands under bltouch on configuration
this is only related to the hardware of the bltouch not leveling related
If you want to use the leveling you just have to add G29 after G28 on the slicer gcode
bear in mind that ubl might have a lot of points so
yo could either connect the printer to the computer and use pronterface
send a g28
then a g29
this instead of using the starting gcode
untold fern
You change that before compiling
I didn't compile it.
I'm not that advanced, I used a precompiled for the SV 01
subtle pivot
yeah since is unified leveling you just have to run it once a week or more