Why did this print fail + why the stringy bits? | 3DMeltdown 3D Printing | Page 1

hollow gulch Jan 1, 2026, 1:03 AM

#

Hey there folks! Tried doing this Spider Gwen print last night and I noticed after not all that long that the main segment failed due to that the foot fell off rather than being held there by the supports. I assume this is a supports issue, so I've included my support settings.
I'm using an H2D with bambu labs PLA white.
I also have noticed that it keeps getting these little stringy bits that end up all over the place. Any way for me to correct that? Pretty new to all this, this is my first print of anything this detailed/non-utilitarian.

merry gale Jan 1, 2026, 2:35 AM

#

No amout of support can compensate for close to 0 firstlayer size

#

I guess that's a resin model?

hollow gulch Jan 1, 2026, 5:14 AM

#

merry gale No amout of support can compensate for close to 0 firstlayer size

I mean my first layer height is 0.2mm, but that said bed adhesion wasn't a problem at all (pulling up supports was almost difficult), rather the foot didn't adhere to the tree support itself and just kind of fell off to the side.
Sorry if I'm misunderstanding

#Why did this print fail + why the stringy bits?