umbral elbow
Trying to get a nice textured first layer. I know it needs to be slightly lower but thats not the issue. Its rough around the borders so im wondering if i should lower acceleration and jerk. Currently doing the initial layer at 7.5mm per second at 220°. Sunlu PLA+
old trellis
Trying to get a nice textured first layer. I know it needs to be slightly lower ...
Bad leveling
umbral elbow
Bad leveling
Highly doubt its leveling, i can print the full bed length and it sticks the same the whole way. I have bed mesh enabled, and the corners are set with a .001 increment dial indicator
willow cave
Either the bed level isnt reading the bed correctly, the mesh isn't being stored or you have a very "non" level bed to start with Top left looks good centre is ok bottom left and top right too far/high bottomleft way too far, you could try first layer at 0.24 as I do for most prints but the bed and mesh are out...
On a positive pressure advance looks good.
umbral elbow
Either the bed level isnt reading the bed correctly, the mesh isn't being stored...
I think my first layer height for that was .4 mm. Before i was at .2mm, gonna have to try those. The mesh is storing because i see the Z screws doing little adjustments during the first layer