fallow sleet
I’m so confused. I finished a print everything was good. I thought before I start the next project I would do some maintenance and cleaned everything and re greased. I do mean I cleaned everything. Then I ran calibration. (AD5X) I printed a test print and what in the world it was chaos! I checked all the screws and such to make sure nothing was loose or over tight. Ran another test print still chaos. Did a wide test square and played with the Z offset still crappy first layer. I ran a temporature test and a flow test. I still feel like it’s a Z-offset and flow problem but I can’t seem to dial it in.
velvet plover
