3DTouch Klipper Config Help | 3DMeltdown 3D Printing | Page 1

sacred ingot Oct 29, 2025, 5:40 PM

#

Does anyone have a klipper config for a 3dtouch wired based off of teaching tech's wiring diagram. using a creality 4.2.2 running klipper with a pi zero 2 w. any help is greatly appreciated

ember rock Oct 31, 2025, 9:14 AM

#

Have you got any of it set up as yet? Also what printer

#

If it's a Ender3 / switch wire then a config should be easy to find

#

Noticed you have the Voron tag, try the switch wire channel

sacred ingot Oct 31, 2025, 2:09 PM

#

can i wire it like a crtouch and use the crtouch config

ember rock Oct 31, 2025, 5:11 PM

#

sacred ingot can i wire it like a crtouch and use the crtouch config

Sorry mate, I don't know, never used a crouch or anything similar

ember rock Oct 31, 2025, 6:41 PM

#

What is the output from the cr touch as all you need is a closed going open or open going closed switch, not sue what the cr touch actually gives you though.

#

Asking AI, it says it is a normally open circuit, with sometimes using a pull up resistor for the voltage, sounds pretty standard, also you could use the normal z stop connector as long as you know what the pin ref is.

#3DTouch Klipper Config Help