Ender 3 V3 KE hitting models

[cold bluff]

I've been having issue printing pieces more then a inch high. The hot end keep hitting the model and dislocate it.
I leveled the Y axis, cleaned the bed with soap, water and IPA. I put a brand new filament (PLA Hyper series of Creality). The bed is leveled ok (see picture).

My spool is beside the printer to reduce vibration.

I've printed at 70C/220C for max adhesion (bed/hot end). I tried 60/200, 65/210, 60/220 combinations.
I'm printing at 350 mm/s max (the printer is said to print up to 500 mm/s).
I'm putting small tree support.
I tried autobrim, brim and even raft for better bed adhesion.
I test the flow and modified to 93% to eliminate the overextrusion.

I can't put the G-code on Discord (90 MB), but it's available to be sent if you can help.

Can you help me? I'm out of solution.

[gilded chasm]

does the issue also happen if you print something in vasemodee?

oh and if your heatbed cable gets squished against the wall you ight want to move tie printer further away to prevent accidental damage

@cold bluff

[cold bluff]

I'll try the vasemode to see.

For the second tip. The cable barely touch the wall. The photo doesn't look like it, but there are spaces there.

[gilded chasm]

Just wanted to mention it 🙂