Hello, my PETG prints seem to always be warping off of the PETG print now that ive started trying to figure out PETG printing again, what am i doing wrong here?
#PETG Print warps off the building plate
clear oyster
clear oyster
i have tried playing around with the temps but when i lower the temps the PETG doesnt stick properly to the bed so it just ends up fucking up the shapes which leads to the prints just completely breaking down after a few layers
stark juniper
First that first layer look too high up, redo the level calibration and make sure you don't start the print before everthing coolsa down. Because ender 3 V3 SE's bed sometimes warp 'cause of heat. And up the temps for the bed. If none of these works try glue on the bed
rare atlas
Based on the photo you have to lower your printhead
Try printing the 1-layer square and tune ypur Z-offset live, while printing
tawdry glade
Also try adding more mm to your bed adhesion layer BRIM