Prints print at a y offset | 3DMeltdown 3D Printing | Page 1

amber kettle Apr 1, 2024, 8:24 AM

#

Ever singe I switched to klipper my prints have been printing lower down the bed than they should. This is because I swapped the old extruder with a biqu H2 V2 but I don't know how to fix this. Is it something in the Firmware, Slicer or both?

raven timber Apr 1, 2024, 9:17 AM

#

Its extruder offset i think or probe offset.

amber kettle Apr 1, 2024, 12:50 PM

#

does this work without a bltouch or something like this installed?

#Prints print at a y offset