I upgraded my extruder and hotend and my prints are now trash even after calibration e-steps. | 3DMeltdown 3D Printing | Page 1

lavish sleet Feb 29, 2024, 11:06 PM

#

Any thoughts on this shitty Benchy?

heavy tusk Feb 29, 2024, 11:59 PM

#

Different retractions maybe now

loud tangle Mar 1, 2024, 11:28 AM

#

Seems like there is something with the exstusion, did u install everything correctly? If its a bowden then u need to make sure that the filament runs smoothly to the hotend. Looks like the extruder isn't getting enough grip on the flament so u tried to compensate it with e-steps

#I upgraded my extruder and hotend and my prints are now trash even after calibration e-steps.