frigid lake
On the pic I das probing the z offset mid print to get the best one but the left part of the layer just does not want to get fixed my adjusting the z height.
What am I doing wrong or how do I fix?
Printer: sovol sv06
Special features: dual z axis, reverse bauden , planetary gears
Pick from the bottom side of the print
scarlet dagger
Your bed is definitely not level (well, trammed correctly to use the correct term)
See it squishing more in the more "solid" area?
frigid lake
how do i fix that?
scarlet dagger
Level the bed
fringe dawn
It's either not leveled or is warped
frigid lake
It’s a magnetic pei sheet the warpeing should be gone by the magnetic sucktion
fringe dawn
That wouldn't happen
The hot bed it's self can warp
I'm not saying that's what's happening just saying it can happen
frigid lake
what should i do noe and should the abl not fix that?
muted relic
I had the same issue with my magnetic spring steel sheet, switched it to a rigid bed - glass and the issue is gone.
The reason for this issue is warped heat bed under the build plate, nothing you can do with it, unless you can straighten it up by any magical way or buy a straight one
amber hemlock
In this case i guess you have one of the two common issues tilted z axis due too low resistance values for homing or abl is off in the startscript of your printer aka no G29 or M420 S1
@frigid lake
frigid lake
so i should increase thehoming sensitivity?
amber hemlock
Lower it a little but id check the startscript /code first
frigid lake
how do i check that?
amber hemlock
Machine setting in your slicer
frigid lake
Very warped
amber hemlock
Hmm check if your x axis is tilted
amber hemlock
X axis is not the bed
frigid lake
X axis fixed bed warped too im fixin it rn
cerulean foxBOT
frigid lake
Just seeing who I’m talking to, but I think my beds level now
amber hemlock
Looks aceptable yes 🙂
vagrant pumiceBOT
frigid lake
gimme 1 sec
The lines are way to visible for my liking, a friend of mine has perfect first layers and no feelable lines
amber hemlock
I mean you can lower the z offset a little more
If thats not working you can reduce the firstlayer line width so you printer compensates for possible underextrusion etc.
frigid lake
Better pic.
amber hemlock
Thats line width or are you printing with .3 mm for first layer?
frigid lake
idk im using slicers defaults
frigid lake
same thing
