factory reset the machine and now this is happening when I do the big calibration?

[teal tartan]

Have you tried .. moving it 1 cm away from the wall?

[obtuse locust]

Yes dosent matter where it is it does the same thing.

[teal tartan]

And can it home normaly

[obtuse locust]

No constantly fails

[teal tartan]

Okay hmm hmm you can try running a firmware update. I guess some stepper values got deleted and thats whats messing it up

[obtuse locust]

I had to factory rest it when I was doing trounle shooting shouldn't that had fixed the problem?

[teal tartan]

Well if you reinstall windows... are all your programms restored?

[obtuse locust]

I says it already has the newest update

[teal tartan]

Hmm weirs

Weird

But since all a1 have an active recall ... i see no problem.to be honest

https://wiki.bambulab.com/en/a1/troubleshooting/a1-recall-faq

[obtuse locust]

No ik, but I kinda need to use the printer, they're only sending me a heat cable replacement not the whole thing

[teal tartan]

Ah okay hmm then youll have to ask them. I was notnable to find a solution online. Personaly i think the values for hit detection are too high after a factory.reset .... but dont ask me where you can set them

[dreamy cradle]

i think maybe something is binding in the z motors or the rods, the sound it makes at the end makes me believe they are not in sync

and that it doesnt know where the gantry actually is in relation to the height