Hello, i have no idea how i can calibrate this, is it retraction or something? Every sharp angle bulges a bit. I guess its from the printer slowing down and some filament is oozing out from the nozzle.
#Bulging corners/fat corners
dapper pewter
onyx wave
things i notice.
brim is being squished, so nozzle too close, might be a z offset thing.
previous issue translates to top layers with bad quality
olive atlas
Increase print temp and jerk speed,
frozen crystal
bulging corners is probably pressure advance
olive atlas
If the printer has it .. most dont
frozen crystal
Both marlin and klipper support pressure advance I think. Your slicer may have like a default number in there
olive atlas
In cura and prusaslicer its off by default
dapper pewter
calibrated linear advance, helped a little bit, idk what pressure advance is or if thats the same thing, i also turned upp the acceleration but the corners are still there
dense summit
Same happends to me, I turned up de acceleration but it is still the same with the corners. How much speed did you set it up?
olive atlas
You need too look for jerk
dense summit
But it depends on the type of fimware/printer right? Some uses Jerk and other the junktion_deviation, iinit? @olive atlas