sturdy tangle
I have this stringing issue that no matter what I do what settings I adjust just will not go away and am looking for any advice on what else I can try before I am forced to change hotend/extruder
ender 5 pro
skr mini with self compiled firmware
slice engineering creality upgrade kit (replaces heat block and heat break)
lgx lite extruder
direct drive
print temp 190
retraction 0.4 speed 40
linear advance 0.06
esteps are set to manufacture recommendation and verified
temp tower prints good from 180-210
retraction tower shows I should be at a distance of 0.4
I have tried the following settings both on and off with no change: combing, zhop, coasting.
Any help would be greatly appreciate at this point I do not know any other calibrations that I can do to fix this stringing issue. I can provide any information needed or print more test.
buoyant imp