Ender-3 S1.
Not Needed For Issue.
PLA.
I was printing something big and when i get back i see that its completely messed up. There is a thin but thick layer of PLA on the bed and its so hard to remove. Even while scratching it.
#Format Below:
knotty oracle
How do i remove it off?
And,
What caused this?
Image of what happened ^
This is a new bed so all em scratches are from the one faulty print.
marble iron
i guess the zoffset failed why cant say you can print over the material
also pro tip
the person helping you makes the decision which information is needed
knotty oracle
i guess the zoffset failed why cant say you can print over the material
I tried printing over it but it scratched the bed (the hotend thing) you can see the long scratch from the middle of the print to the bottom.
knotty oracle
Alright. How should i remove the current PLA on the bed?
marble iron
you print over it other methods wont really work on that bed
knotty oracle
So there is no way to rub it off right?
marble iron
pff nothing that works definitly or could not damage the bed
you can heat up to 100 and try peeling it off
knotty oracle
you print over it other methods wont really work on that bed
I would do that but when i print the filament wont stick to the actual bed this happened before this issue too.