Bed adhesion problems

[cursive sleet]

can someone help wiith this ive currently experrienceing clumping on serface and curcling peeling off print bed. Ender 3 v2, .4 nzzle, CR touch,pei sheet, direct drive, dual z axis,

even while prnting at slow as 10mm/s

[royal heron]

Material? And temps?

[cursive sleet]

@royal heron 190 PLA

190 bc i did a temp tower and it looked the best

[royal heron]

and bed temp?

and print speed

[cursive sleet]

60

bed temp

and i trid printing

from

30 to 100

mm/s

same resultsa

also tried to lower and raise my z offset

[cursive sleet]

i also tried swapping filament]

with a recently "dried" filament

[royal heron]

You sure abl is on in the start script

[cursive sleet]

no idea what that is

[elfin gust]

Auto bed level.

[cursive sleet]

yes

i did