help me with my bed leveling

[woven rover]

Did you level the bed without the touch?

Cuz even tho you have the touch u still need. To. Level the bed

[dim trellis]

Yes

One sec does the bed come with oil on?

I'm cleaning it to the fullest

[dim trellis]

How do I correctly level the bed?

[dim trellis]

Ok fixed

Thanks anyway

[woven rover]

Use a piece of paper. Auto home the printer disable steppers

Put the paper under where the nozzle does auto home

After you disable steppers you can move the print head. Manually

When you pull on the paper you should feel reaistance

You don't want it to be tight enough that it won't move

But you also don't want it to slide easily

You are gonna have to do this a few times to get it right and figure out the correct reaistance

Do it 4 all 4 corners till they all feel the same

The do the middle

If the middle is off do the corners again

[dim trellis]

It's done

How do I remove this post?

[hasty flame]

@dim trellis can you help me with leveling? i dont know what im doing wrong. i tryed with paper leveling but first layer not sticking

[dim trellis]

Does the printer have a auto bed leveling?

[hasty flame]

yea. Ender 3 s1

[dim trellis]

Try tuning the z offset

If that does not work clean the build plate with soap and water

[hasty flame]

mabye i made wrongly manual leveling. I screwed 4 wheels down

are you but something in bed when you print some glue something?

[tiny cave]

you tightend all 4 springs down or were your roller wheels loose

[hasty flame]

Fixed. Made manual leveling again and fixed z-offset

maded 220° and speed 100. maybe the nozzle is too close

?

[tiny cave]

what is sthe question