simple meadow
I have a modded anycubic i3 Mega
And I can’t resolve an issue that I have so every response are welcome ;)
I have changed everything lastly whit SKR 1.4 and bltouch
Before my print were really great I was able to print without any support and only the heating bed it was really great
But the heat wrap my bed so I have a very little use surface so I thinked bltouch could help whit that
But now that I have bltouch nothing is working
I think I have done everything correctly
I have set all the stepper correctly they move the wanted length
I have set all the offset of the bltouch X Y Z
i have put the bed mesh in the middle of my bed so it can’t cover everything but cover easily 70% of it whit 6x6 probing
Sooooo yeah I have checked everything many times and I can’t know why :
My bed adhesion is very bad
The left side is ok
But the right side not it’s chaotic the nozzle wen on it the PLA stick to the nozzle ?!
I don’t understand whyyyyyy because the bltouch should compensate ????
And yes I have manually leveled my bed multiple times
Yes I do the bed mesh wen the bed is heated too
Yes I have tested the probe accuracy it’s 0,0025