make a video of it failing, get up in there with the camera.
#print not sticking
onyx moth
how are you sending the print to the printer? sd card? @rancid eagle
that's the gcode you're putting on the sdcard. drag and drop it into discord so I can see it
can you get a more top-down picture/video of the plastic on the bed. my first guess would be your nozzle is too far from the bed. but the angle makes it hard to observe.
no. I want a more top-down view. 😛
but. yeah, the nozzle is too far from the bed
if you're confident in your "leveling" you can just equally raise all four corners a quarter turn or so until it works
onyx moth
ideally, but I won't tell if you won't tell if you do it cold.
onyx moth
paper isn't a precision tool, but it can help you get the corners consistent at least
once you're confident it's consistent you can adjust things in software with a z offset or by adjusting all four knobs equal amounts
hmm?
how are you changing the z offset?
just change it in the menu and save the settings if necessary. nothing else should be needed
my first guess would be that your nozzle is still too far away
you can stop leveling it. manually raise the bed or lower the nozzle with the z offset until it's not too far away
there is no bed leveling probe on this printer, right? all manual?
then yeah, raise bed or lower nozzle
onyx moth
make a video of it attempting to print from more top down view please
camera above the bed. top-down, please
please stop having the camera from the side
