little points on print surface

[dense sparrow]

Little points on print surface, i’m using a biqu b1 with cura 5.3, the filament is perfectly dry and i have already trier reducing infill overlap, any suggestion ?

[solid saddle]

Bed leveling???

[dense sparrow]

bed leveling is completly ok, im using raft

[solid saddle]

I’m not qualified 😭

[austere falcon]

Take a look at the rendering of the sliced data and then check the options to show seams

I bet you are running random seams and not aligned or nearest

[dense sparrow]

seam is aligned on the same corner every layer

[austere falcon]

Is that the gcode render?

[dense sparrow]

slicer render yes

[craggy rivet]

Attach the gcode please

[craggy rivet]

gcode is mostly fine. my guess is the terrible stock extruder isn't gripping the filament properly

[dense sparrow]

I upgraded it to a dual gear extruder already

[craggy rivet]

which one?

[dense sparrow]

c'est classic one , red

[north citrus]

Where did you get it I need one

[covert pier]

https://www.cnckitchen.com/blog/removing-zits-and-blobs-on-your-3d-prints-adjust-your-slicing-resolution